Iprog Rework [SAFE]

while powering on the device.

The goal was simplicity. The operator shouldn't have to think. The new interface features a single large "PROGRAM" button, automatic device detection, and a color-coded status bar. No more digging through menus to set voltage levels—the software queries the target and sets the VCC automatically. iprog rework

: If you don't have a 0.22 Ohm resistor, you can solder three 1 Ohm resistors in parallel to achieve approximately 0.33 Ohm, which is usually sufficient. while powering on the device

: Using generic parts where high-precision components are required for timing-sensitive protocols like CAN or K-Line. The Core Components of a Successful Rework automatic device detection