Foxconn N15235 Motherboard Front Panel Connectors Jun 2026

If your Power LED connector is 3-pin (common on older cases), the middle pin is unused. You may need to split it into two 1-pin connectors or carefully plug the 3-pin so that the two active wires go to pins 2 and 4, leaving the middle hole over pin 3 (which is HDD_LED− – no conflict but may cause odd behavior if connected). Convert to 2-pin by removing the unused middle wire.

. This header connects your case's power button, reset switch, and LED indicators Front Panel Header Pinout (JFP1) foxconn n15235 motherboard front panel connectors

If you see "F_AUDIO" or "USB," you are in the wrong area. Those are for audio jacks and USB ports, not power/reset switches. If your Power LED connector is 3-pin (common

Insert the RESET SW cable onto pin 7 (top row, fifth pin from left) and the corresponding ground on pin 5 (top row, third pin from left). If you only have two pins for reset, align it so it bridges pin 7 and the ground pin next to it. Insert the RESET SW cable onto pin 7