Set to "Full Scan" or "Low Level Format" to bypass the FA00 error. Click OK to save settings. Step 3: Flash the Firmware Click the Start (A) button on the main screen.
The error message "Alcor Micro Unknown [FA00] - F/W FA04" indicates that your flash drive's controller (Alcor Micro) is stuck in a "no-FID" or uninitialized state, often appearing as "No Media" or with 0GB capacity. The Technical Fix: AlcorMP Tool alcor micro unknown fa00 f w fa04 fixed
Usually code 0x02 (Bad block too many) or 0x03 (Flash ID mismatch). This means your NAND chip is degraded. Try "Erase All Blocks + Low Level Format" again, but accept that the drive may be dying. Set to "Full Scan" or "Low Level Format"